top of page

Manufacturing Update

Media Director

Nov 12, 2024

All final production products are being swapped to PETG filament.

Per the recommendation of our Chief Design Engineer, we are swapping all final production parts for all our products to PETG filament.


We apologize for any confusion or inconvenience this may cause.


All current PLA products will be discontinued immediately and no longer be sold.


The reason for the swap was there were valid concerns brought up over PLA's heat resistance properties concerning temperatures inside of cars in the summer in hot areas around the world.


We understand that PETG will not provide the fully desired heat resistance in some of the hottest parts of the world, but we are working to address this issue as we are in the process of expanding our production materials to include Nylon and ABS printing filaments.


If our product fails due to extreme heat, please don't hesitate to contact us as it would be covered under our Limited Lifetime Warranty, and we would be happy to replace or refund the product.

bottom of page